Getting your car key unstuck from your ignition is dependent on the situation. How to Get a Stuck Key Out of the Ignition Even if it’s not, it’s a good idea to check to get the status of any other outstanding recalls or TSBs. You can check to see if your vehicle is affected by entering your VIN number in the National Highway Traffic Safety Administration (NHTSA) website. While rare, there is the possibility that your particular year, make, and model of car or truck is subject to a recall or technical service bulletin (TSB) directly related to the ignition lock cylinder. If these pins are slightly out of alignment, it can prevent you from removing the key (or even inserting it in the first place). This is because there are several rows of spring-loaded pins inside the ignition lock which match up with the shape of your key when inserted. If you have an ignition lock cylinder that’s on the verge of failing, it can prevent your key from coming out. Replace the key immediately if you start noticing this damage. If it ever bends or forms a small crack somewhere, then it will be tougher to remove it from the ignition. This kind of abuse will slowly damage your car key. When aren’t not using your car key, you may keep it in your pocket or toss it onto a hard-surfaced desk. Each time you put the key in the ignition and turn, it wears the key just a little bit. #5 – Worn or Damaged KeyĬar keys can take a lot of abuse over the years. Either that or use a tack hammer and gently tap the cylinder with it. The best thing you can do here is to wait for a jump start or new battery to be installed. Then you won’t be able to get the key out of the ignition. If the battery dies, it will likely cause the ignition system to lock up. The ignition system depends on power from the battery to function properly. If you were to then place the key into the ignition of your vehicle while the tape is still stuck to it, then it will be harder for the key to engage the ignition cylinder’s pins. While this might be effective at tearing through the box tape, it could also cause pieces of the tape to stick to the key. Some people like to open boxes and packages with their car key. You should be able to take the key out now or start the engine. To release both locks at the same time, try turning the key while wiggling the steering wheel around. This is due to the ignition cylinder locking at the same time as the steering wheel lock. Not only will this prevent you from turning the steering wheel, you won’t be able to pull out the key from the ignition either. If you turn off your vehicle while moving the steering wheel just a little bit, the steering wheel lock will activate. If your vehicle has a digital screen which displays the gear settings, check that to ensure the “P” is highlighted. Sometimes people may attempt to change the gear to park, but the gear doesn’t get set all the way over to it. In a manual transmission, make sure the gear shifter is set to “Neutral” and not in any other gear. In an automatic transmission, if the gear is set to drive, neutral, or any other available gear, then the key will not come out. The gear of the transmission must always be set to “Park” before attempting to remove a car key from the ignition. Below are the top 7 causes of a key getting stuck in the ignition. You just need to understand these causes so that you can figure out the solution to the problem. However, most causes of key sticking are universal and can happen in any make and model vehicle. Some of these reasons may pertain to a unique problem in a specific make and model vehicle. There are a variety of reasons as to why your car key won’t come out.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |